An automatic bypass valve inside the pump prevents pressure build up when the pump is on with
the nozzle closed. To avoid motor damage, do not
run the pump more than 5 minutes with the nozzle
closed.
The rated duty cycle of this pump is 15 minutes
ON and 30 minutes OFF. Allow the pump to cool
for 30 minutes.
The EZ-8 is designed for use with gasoline (up to
15% alcohol blends such as E15), diesel fuel (up
to 20% biodiesel blends such as B20) and kerosene only. Do not use this pump for dispensing
any fluids other than those for which it was designed. Doing so may damage pump components
and will void the warranty.
The EZ-8 Methanol pump is specifically designed
for use with methanol and ethanol. The pump is
also compatible with gasoline (E15), diesel fuel
(B20), and kerosene. Do not use this pump for
dispensing any fluids other than those for which it
was designed. Doing so may damage pump components and will void the warranty.
SAFETY INSTRUCTIONS
Observe all safety precautions concerning safe
handling of petroleum fuels.
To ensure safe operation, all fuel transfer systems
must be properly grounded. Proper grounding
means a continuous metal-to-metal contact from
one component to the next, including tank, tank
adapter, pump, meter, filter, hose, and nozzle.
Care should be taken to ensure proper grounding
during initial installation and after any service or
repair procedures. For your safety, please take a
moment to review the warnings below.
• To prevent physical injury, observe precautions
against fire or explosion when dispensing fuel.
Do not operate the system in the presence of
any source of ignition including running or hot
engines, lighted cigarettes, or gas or electric
heaters.
Observe precautions against electrical shock
when operating the system. Serious or fatal
shock can result from operating electrical
equipment in damp or wet locations.
Inspect external pump wiring regularly to
make sure it is correctly attached to the battery. To avoid electrical shock, use extra care
when connecting the pump to power.
Avoid prolonged skin contact with petroleum
fuels. Use protective goggles, gloves, and
aprons in case of splashing or spills. Change
saturated clothing and wash skin promptly
with soap and water.
Observe precautions against electrical shock
when servicing the pump. Always disconnect
power before repairing or servicing.
Never apply electrical power to the system
when any of the coverplates are removed.
Ensure that all operators who use this pump
are educated on its function and precautions. All operators must have convenient
access to adequate instructions concerning
safe operating and maintenance procedures
contained in this manual.
Ensure all fluid connections to and from the
pump are properly sealed and tightened with
appropriate thread tape, gaskets, or o-rings.
If using solvent to clean pump components
or tank, observe the solvent manufacturer’s
recommendations for safe use and disposal.

This pump is designed to operate on a typical 12-
volt DC automotive electrical system. The pump is
designed to operate with 12-volts DC at the motor
leads, and the ratings are determined at that voltage. Performance may vary due to length of power
cord, battery condition, or output from vehicle
charging system affecting system voltage.
Do not leave the system running without fluids.
“Dry running” can damage the pump. If the system fails to deliver fuel after 15 to 20 seconds, turn
the system off and refer to the Troubleshoot- ing
Section.
Do not completely empty the fuel tank, as contaminants from the bottom of the tank may enter the
pump

Download Now!

Enquire Now!